Homedics PedicureSpa Salon Footbath HL200-1 Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
Maintenance
To Clean
Unplug the unit and allow it to cool before
cleaning. Clean only with a soft, damp cloth and
mild cleansing agent.
After cleaning, wipe surfaces with a dry cloth.
Never use strong abrasives, detergents or
cleansing agents.
Periodically straighten cord if it becomes
twisted.
To Store
Unplug the appliance from the outlet and allow
to cool and dry.
Gently wrap the power cord around the feet
and secure with the cord hook.
Store in its box or a clean, dry place.
Do not hang the unit by the power cord.
This appliance is designed for household
use only.
6
7
Instructions for Use
1. Ensure that the unit is unplugged before filling with water. Lift the carry handle into the full up-
right position (Fig 2) and carry to a water faucet. Fill with warm water to the fill line located on
the inside of the tub (Fig 1). When finished, carry tub to a flat, steady surface for use and
place handle in resting position (Fig 2).
NOTE: Heat will only help to maintain the temperature of water placed inside the footbath. It
will not heat cold water. For a warm water massage, fill the unit with warm water.
2. Plug the unit into a 120 volt household outlet.
3. Sit down in a comfortable position. With the touch of your toe, press the on/off button (Fig 1)
to enjoy a warm bubble massage. The LED will illuminate to indicate it has been selected.
Place your feet in the spa. Press again to turn the feature off.
4. To use the Pull-Out Pedicure Tool:
a. Select the desired attachment from the covered storage (Fig 1):
Dry Heel Reducer: Removes rough spots and reduces dry skin on your heels
Stone Pumice: Exfoliates the heels and balls of your feet to smooth and soften dry skin
Finishing Pumice: Gently exfoliates to provide a smooth finish
Nail Brush: Use to cleanse and exfoliate your feet
Nail Buffer: Smooths and shines nails
b. Simply place the attachment on the pull-out pedicure center post (Fig 1).
c. Press the on/off button on the tool (Fig 1).
d. When finished turn the tool off and remove the attachment. Place the attachment back
into the covered storage area and close the lid.
e. Using the Side Tabs (Fig 1) lift the Comfort Gel Footrest out of the center console (Fig 1).
Place the Pull-Out Pedicure Tool and cord back into console and secure to suction cup.
f. Put Comfort Gel Footrest back into console.
5. Enjoy a deep penetrating massage by sliding feet back and forth over the Massaging Sea
Grass™, or you can remove the Sea Grass and rejuvenate with the raised nodes
on the footbath floor.
6. To empty: First, unplug the unit. Lift the carry handle into the full upright position and take the
footbath to the closest drain.Tip the unit, allowing water to pour out along the drain spout. DO
NOT pour water over the control panel (Fig 1).
Drain Spout
Fill Line
Figure 1
Attachments
Control
Panel
Comfort Gel
Footrest
Massaging
Sea Grass
Handle
Covered Storage Area
Figure 2
Caution:
To avoid injury and
irreparable damage,
always remain seated
when using this foot-
bath. Never stand on or
in the unit.
CAUTION: THIS UNIT
CAN ONLY RUN WITH
WATER IN IT. DO NOT
USE WITHOUT WATER.
CAUTION:
DO NOT FILL WATER
OVER THE FILL LINE
Upright
Resting
Center Post
On/Off Button
Side Tabs
Nail Brush
Stone
Pumice
Dry Heel Reducer
Finishing Pumice
Nail Buffer
Vue de la page 3
1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire